Inverter Features; Prepare For Installation - Fullwat PDA-D Serie Manual De Instrucciones

3. INVERTER MATERIAL LIST
The inverter ships with the following items: inverter unit, manual, spare fuse, DC cables and one ON/OFF remote switch with
communication cable (optional).
IMPORTANT: keep the carton and packing material in case you need to return the inverter for servicing.
Inverter unit for MS & MSD Series 1000-3500W
* The image shown here is indicative only,
pls refer to the actual product.

4. INVERTER FEATURES

This section describes the different parts of the inverter.
3
1
5
Output AC panel.
4
Input DC panel.
* The image shown here is indicative only, pls refer to the actual product.
5. INVERTER INSTALLATION
This section describes general installation instructions for the power inverter.
IMPORTANT: Use a qualified installer if you do not possess the knowledge and skill necessary to follow these general instructions.

5.1 PREPARE FOR INSTALLATION

• Design your power system.
• Calculate your battery requirements.
• Choose an effective charging system.
• Choose an appropriate location.
• Use suitable enough size wires for DC poles and ground connections.
Take into account that size wires affect to final voltage reached to inverter input from battery.
Best performances status is achieved with a combination of full charged and healthy battery plus suitable size connection
wires.
7
4
1
2
6
2
1 3 4
Remote control PDA-REM-C/D
ON-OFF remote switching.
5 mt cable included.
Optional part to be ordered separately
AC outlets are used to power loads.
1
2 ON/OFF Switch turns the Inverter on and off.
Fault light (red) indicates that the inverter has shutdown due to
3
inverter overload, over temperature, short circuit, and leakage, etc.
or failure status.
Power light (green) indicates the inverter is operating.
4
USB port with output DC5V 500mA or 800mA or 2.1A (optional) for
5
charging for your appliance.
Remote ON/OFF connector port is used for connecting the ON/OFF
6
remote switch.
Digital display panel indicates the input voltage from battery and
7
the rate of loaded power.
Negative DC Input terminal always connects to the negative
1
terminal of the battery via a negative DC input cable (black battery
cable). The negative DC input terminal is colored black.
Positive DC Input terminal always connects to the positive terminal
2
of the battery via a positive DC input cable (red battery Cable). The
positive DC input terminal is colored red.
Chassis ground screw connects to vehicle chassis, DC grounding
3
bus or engine's negative bus or grounding the earth.
Ventilatlon openings must not be obstructed for the proper
4
operation of the inverter. When the inverter is mounted, then
ventilation opening on the DC panel must not point up or down.
- 12 -
DC cables
User Manual
Fuse