Unrolling The Hose; Rolling Up The Hose; Adjusting The Hose Stopper; Maintenance And Cleaning - Parkside PDST 10 B3 Traducción Del Manual De Instrucciones Original

Manguera de aire comprimido con tambor
Ocultar thumbs Ver también para PDST 10 B3:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 74
The locking device generates a clicking noise
when rolling up and unrolling . This is not a fault .
If the noise changes after using the equipment
numerous times and/or if there are problems
with the mechanism, seek expert assistance or
contact customer service .

Unrolling the hose

Pull the compressed air hose 5 carefully out
of the drum housing to the desired working
length for the pneumatic tool . If you release
the compressed air hose 5 after a click, the
locking device engages at this length .

Rolling up the hose

A short pull on the compressed air hose 5
releases the lock .
Make sure that the compressed air hose 5 rolls
back into the drum housing 1 in a controlled
manner .

Adjusting the hose stopper

The position of the hose stopper 4 can be
adjusted and interrupts the rolling up of the
compressed air hose 5 to the desired length . You
will need a Phillips screwdriver (not included) to
adjust the hose stopper 4 .
Undo the fastening screws 9 with the Phillips
screwdriver (see fig . D) .
Slide the hose stopper 4 along the
compressed air hose 5 to the desired position .
Retighten the fastening screws 9 .
6 
GB │ IE

Maintenance and cleaning

NOTE
The compressed air hose reel must be
serviced regularly and overhauled to ensure
proper functioning and compliance with
safety requirements . Improper and incorrect
operation can lead to failures and damage
to the appliance .
Never use harsh and/or abrasive cleaning
agents or solvents . These could damage the
plastic parts of the compressed air hose reel .
Never allow water to get inside the compressed
air hose reel . Make sure that the housing and the
compressed air hose remain free of dust and dirt .
To ensure this is the case, wipe the compressed
air hose reel regularly with a clean cloth .
Before returning the compressed air hose to the
housing, clean the compressed air hose for
further use if possible .
Clean the compressed air hose reel and the
hose with a damp cloth and a little soap at
regular intervals .
PDST 10 B3

Publicidad

Tabla de contenido
loading

Tabla de contenido