Start-Up - GOK SmartBox MINI Instrucciones Para El Montaje Y Para El Uso

Cable extension/wall duct options
Recommended cable extension with a LIYY cable, cable cross-section
2
5 x 0.25 mm ; cable diameter 4.5 to 6 mm (up to 50 m extension possible).
Extend the connection cable and/or pass through a wall:
• Remove the clip-on ferrite core
• Extend the connection cable or pass it through a wall:
• Replace the clip-on ferrite core
• Connect the cable to the digital display unit (see above).
• Position the clip-on ferrite core near the housing.

START-UP

Operating elements and screen of the digital display unit
The device is adjusted once when it is put into operation. The digital display unit is put into
operation after the cable has been connected and the batteries have been inserted.
When it has been started, the digital display unit works in display mode. The readings are
shown in a 1-line LCD display with 16 characters. The display has background lighting so that
the readings can be seen in all lighting conditions.
View of the digital display circuit board-sectional view,
Terminal assignment from left to right:
1 2
ws = White bn = Brown
Setting a
parameter:
Quitting the
setup mode:
Programming 1st steps
You can enter the parameters before the "Set Null" zero offset adjustment between
the digital display unit and the FSA-E or also after "Set Null".
16 / 87
from the cable.
on the cable.
3
gn = Green gb = Yellow
Press [ENTER] to open setup mode.
Select the desired setting parameter via [PLUS].
Press [ENTER] to call up the value selection for the parameter.
Set the value with [MINUS]/[PLUS], press [ENTER] to save.
You can quit the setup mode at any time.
Select "Exit" and press [ENTER]
 to go back to the standard display mode.
1. Touch the sensor bar to activate the display.
2. Press [Enter] button.
3. The 1st menu item "Unit" is displayed.
4 5
gr = Grey
SmartBox MINI
The parameters are adjusted
with three small push-
buttons:
MINUS ENTER
SW6 SW4
These are located on the
circuit board above the
terminal block.
PLUS
SW5
28 900 50 a