Troubleshooting; Restoration; Maintenance; Shut-Down - GOK SmartBox MINI Instrucciones Para El Montaje Y Para El Uso

1. Loosen the screw on the bottom of the digital display unit and remove the top of the
housing.
2. Place the digital display unit on a suitable position on a smooth, vertical wall and pierce
the pre-cut holes on the inside back wall of the housing. Mark the points for installation.
3. Place the digital display unit on the marks and fix it in place using the supplied anchors
and screws.
4. Close the top of the housing and tighten the screw on the bottom of the digital display unit.

TROUBLESHOOTING

Fault cause
Battery warning Battery _ _%
when remaining capacity is low
No display Batteries empty
Error code
Error 0001
Error 0002
Reset: remove/insert batteries

RESTORATION

If the actions described in TROUBLESHOOTING do not lead to a proper restart and if there is
no dimensioning problem, the product must be sent to the manufacturer to be checked. Our
warranty does not apply in cases of unauthorised interference.

MAINTENANCE

Replacing the batteries
1. Loosen the screw on the top of the housing, remove empty batteries from the display unit
and insert new batteries (3 x AA 1.5V batteries) paying attention to the "+" and "-" poles.
2. Replace the top and tighten the screw.
Stored data is not lost when you replace the batteries.

SHUT-DOWN

Pay attention to the following when you take the digital display unit out of service:
Damage to device from leaking batteries
Can damage the device.
If the digital display device will not be used for some time, remove the batteries.

TECHNICAL CHANGES

All the information contained in this assembly and operating manual is the result of product
testing and corresponds to the level of knowledge at the time of testing and the relevant
legislation and standards at the time of issue. We reserve the right to make technical changes
without prior notice. Errors and omissions excepted. All figures are for illustration purposes
only and may differ from actual designs.
20 / 87
Action
 Constant check
 Replace batteries
Meaning
No contact with FSA-E:
Check the connection between the magnetic sensor and
the magnetic encoder in the connection plug on the FSA-E.
Reset.
Connection cable on the digital display unit not connected:
Connect the cable.
Reset.
SmartBox MINI
28 900 50 a