Preparing The Measurement - Beurer BM 57 Instrucciones De Uso

4. Preparing the measurement

Inserting the batteries
• Remove the battery compartment
lid on the rear of the device.
• Insert 2x 1.5 V AA (alkaline type
LR06) batteries. Make sure that the
batteries are inserted the correct
way round. Do not use rechargeable
batteries.
• Close the battery compartment lid
again carefully.
All display elements are briefly displayed,
display. Now set the date and time as described below.
If the battery replacement symbol
yed, you can no longer perform any measurements and must
replace all batteries. Once the batteries have been removed
from the device, the date and time must be set again. Any
saved measured values are retained.
Set the hour format, date, time and Bluetooth
The following section describes the functions and settings
available on the blood pressure monitor.
Hour format Date
➔
It is essential to set the correct date and time. Otherwise, you
will not be able to save your measured values correctly with a
date and time and access them again later.
If you press and hold the M1 or M2 memory button, you
can set the values more quickly.
2 x 1,5V AA
flashes on the
is permanently displa-
® settings
Time ➔ Bluetooth
➔
Press and hold the START/STOP
you have not reinserted the batteries.
The hour format now flashes on the display.
• Select the desired hour format using the
M1/M2 memory buttons and confirm with
the START/STOP button
The year flashes on the display.
• Select the year using the M1/M2 memo-
ry buttons and confirm with the START/
STOP button
The month flashes on the display.
• Select the month using the M1/M2 memo-
ry buttons and confirm with the START/
STOP button
The day flashes on the display.
• Select the current day using the M1/M2
memory buttons and confirm with the
START/STOP button
If you have set the 12h hour format, the month is
displayed before the day.
®
23
button for 5 seconds if
.
.
.
.