Beurer BM 57 Instrucciones De Uso página 25

Now insert the cuff line into the
connection for the cuff connector.
If the measurement is performed
on the right upper arm, the line
should be located on the inside of your elbow. Ensure that
your arm is not pressing on the line.
Blood pressure may vary between the right and left arm, which
may mean that the measured blood pressure values are diffe-
rent. Always perform the measurement on the same arm.
If the values between the two arms are significantly different,
please consult your doctor to determine which arm should be
used for the measurement.
Important: The unit may only be operated with the original
cuff. The cuff is suitable for an arm circumference of 23 to 43 cm.
Adopting the correct posture
• Before every measurement, relax for about five minutes.
Otherwise deviations can occur.
• You can take the measurement while sitting or lying down.
Always make sure that the cuff is at heart level.
• To carry out a blood pressure measurement, make sure you
are sitting comfortably with your arms and back leaning on
something. Do not cross your legs. Place your feet flat on the
ground.
M1
• To avoid falsifying the measurement, it is important to remain
M2
still during the measurement and not to speak.
Performing the blood pressure measurement
As described above, attach the cuff and adopt the po-
sture in which you want to perform the measurement.
• Press the START/STOP button
the blood pressure monitor. All display
elements are briefly displayed.
The blood pressure monitor will begin the
measurement automatically after 3 se-
conds. The measurement is taken during
the inflation phase.
You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
displayed.
• The systolic pressure, diastolic pressure
and pulse rate measurements are displa-
yed.
• appears if the measurement could not
be performed properly (see chapter 10
"Error messages/troubleshooting"). Re-
peat the measurement.
25
to start
.
will be