Sending A Call Tone - Maxell RAD-2 Manual De Usuario

EN
10. Scanning for an active radio channel:
• Press the SCAN-button (21):The "Scan" function indicator (17) will appear on the
screen and the channel (18) will scan continuously from 1 to 8 /20/22
• Press the -button (7) to start the channels can from 8/20/22 to 1. Once an active
channel is found, the scanning will stop and you can listen to the transmission.
When the transmission on the found channel stops, the scanning will resume
automatically.
Note: If you press the TALK button (15) while listening to a found channel, the
radios will go back to stand-by mode on the found channel.
11. Call Tones:
A call tone will alert others that you want to start talking.
11.1 Setting the Call Tone
The Twintalker has 10 call tones.
• Press the MENU-button (11) four times, "CA" is displayed and the current call
tone will be ashing.
• Press the ▲ button (4) or the ▼ button (7) to change to another Call Tone.
• Press the TALK-button (15) to con rm and return to standby Mode.

11.2 Sending a call Tone

• Press the CALL-button (12) brie y. The call tone will be transmitted on the set
channel.
12. Key-Tone On/O :
When a button is pressed, the unit will beep brie y.
To set the key-tone:
• Press the MENU-button (11) ve times. "to" will be displayed.
• Press ▲ to enable (ON) or ▼ disable the Key Tones (OFF)
• Press the TALK-button (15) to con rm your selection and return to standby
mode.
13. Roger Beep On/O :
After the TALK button is released, the unit will send out a roger beep to con rm
that you have stopped talking.
To set the Roger Beep:
• Press the MENU-button (11) six times. "ro" will be displayed.
• Press ▲ to enable (ON) or ▼ disable the Roger Beep (OFF).
• Press the TALK-button (15) to con rm your selection and return to standby
mode.
7