H-1208
30" NOSE EXTENSION
FOR ALUMINUM
HAND TRUCKS
TOOLS NEEDED
1/2" Wrench
Figure 1
2
5
3
7
6
Nose Plate
NOTE: If you are adding the folding nose
extension to an assembled hand truck, remove
four 5/16"–18 x 2⁄" – hex head bolts from the
nose plate and discard the bolts. Keep the
locknuts. If you are installing on a new hand
truck, proceed to step 1.
1. Attach "L" brackets to the inside of the nose plate
using 5/16"–18 x 2⁄" – hex head bolts and four
5/16"–18 – locknuts. (See Figure 1)
2. Position the folding nose extension so both of the
folding nose brackets are on the outside of the "L"
brackets with the holes aligned and the crossbar
rivets facing up. (See Figure 1)
PAGE 1 OF 3
1-800-295-5510
uline.com
PARTS
7
5
4
6
7
4
Folding
Nose Brackets
ASSEMBLY
REF.
QTY.
1
1
2
2
3
4
4
2
5
2
6
2
7
2
*Additional four locknuts required for assembly
are included with hand truck hardware.
1
3. Attach the folding nose extension to the "L" brackets.
(See Figure 1)
a. Slide one 5/16"–18 x 1" – hex head bolt through
the folding nose bracket (toward the inside of the
extension). Slide a flat washer over the bolt.
b. Slide the bolt through the "L" bracket. Slide a
spherical washer over the end of the bolt and
secure with one 5/16"–18 – locknut but
DO NOT TIGHTEN.
c. Repeat for the other side.
d. Tighten all locknuts.
Para Español, vea página 2.
Pour le français, consulter la page 3.
DESCRIPTION
Folding Nose Extension
"L" Bracket
5/16"–18 x 2⁄" – Hex Head Bolt
5/16"–18 x 1" – Hex Head Bolt
Flat Washer
Spherical Washer
5/16"–18 – Locknut*
0521 IH-1208