NORPOLE NPPAC8KW Manual Del Propietário página 9

FAN operation
- Press the MODE button until the FAN indicator light illuminates.
- Press the FAN SPEED button to choose the desired fan speed.
-
Under FAN mode, the temperature cannot be adjusted.
- Do not install the window duct.
TIMER operation
- While the unit is on, press the TIMER button. The TIMER OFF indicator light will illuminate. This
indicates the AUTO STOP feature has been initiated
-
While the unit is off, press the TIMER button. The TIMER ON indicator light will illuminate. This
indicates the AUTO START feature has been initiated
-
Press or hold the UP or DOWN button to change the AUTO time by 30 minute increments (up to 10
hours), then at 1 hour increments (up to 24 hours). The control will count down the time remaining until
start.
-
The selected time will register for 5 seconds and then the system will automatically revert back to
display the previous temperature setting.
-
Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will cancel the AUTO
START/STOP timed program.
- When an error occurs (E1 or E2), the AUTO START/STOP timed program will also be cancelled.
SLEEP operation
- Press the SLEEP button to activate the sleep feature.
Within 30 minutes, the selected temperature will increase (cooling) or decrease (heating – on some
-
models) by 2°F (1-2°C).
After an additional 30 minutes, the temperature will again increase (cooling) or decrease (heating – on
-
some models) by 2°F (1-2°C).
- The new temperature will be maintained for an additional 7 hours before the unit returns to the originally
selected temperature setting.
-
At this time, the SLEEP mode will end and the unit will continue to operate as originally programmed.
NOTE: This feature is unavailable under FAN or DRY mode.
All manuals and user guides at all-guides.com
8