Getting Started; Using The Fl Menu - Marantz DV8400 Guia Del Usuario

All manuals and user guides at all-guides.com
4

Getting Started

Using the FL menu

The FL menu has been designed to set
"DISP MODE", "AUTO P OFF" and
"REMOT CODE".
The FL menu can not be used if a disc is
playing.
It is recommended to set the FL menu
before loading a DVD.
If a DVD has been loaded, be sure to press
STOP 7 twice before proceeding.
(If "RESUME" is displayed in the FL display,
press STOP 7.)
Selecting the FL menu
Press SETUP for longer than 1 sec.
The FL OFF indicator on the player turn on and
off.
FL menu is displayed in the FL display.
SACD/DVD PLAYER
STANDBY
DISP MODE
POWER
ON/OFF
FL menu
Use the cursor buttons (5/∞) to select the FL
menu you want as follows.
(Example)
DISP MODE
AUTO P OFF
REMOT CODE
To exit the FL menu
When you have compleated setting up the FL
menu or if you want exit the FL menu. Press
SETUP to close the FL menu.
DISP MODE setting
Select DISP MODE, then press ENTER.
Use the cursor buttons (5/∞) to select the type
of DISP MODE you want to set as follows.
16
FL OFF
PLAY STOP PAUSE
FL OFF OPEN/CLOSE
(Example)
*
DISP OFF
DISP ON
* Factory setting
Press ENTER you want to set.
The menu select is set.
• If you play a CD, MP3 or Super Audio CD while
DISP ON is selected, FL display and video
output shut off automatically. FL display is on
and video output is off during Stop. And if you
push the DIMMER button on the remote
control or FL OFF button on the front panel
during DISP ON, for three seconds, only FL
display is displayed.
• Depending on the disc, it may not operate
normally. When this happens, use it after
turning off DISP MODE.
AUTO P OFF setting
Select AUTO P OFF, then press ENTER.
Use the cursor buttons (5/∞) to select the type
of AUTO P OFF you want to set as follows.
(Example)
*
ON 30 MIN
OFF
* Factory setting
Press ENTER you want to set.
The menu select is set.
• The standby mode is automatically selected to
save power if the player is left in the stop mode
for about 30 minutes.
REMOT CODE setting
Select REMOT CODE, then press ENTER.
Use the cursor buttons (5/∞) down to select
the type of REMOT CODE you want to set as
follows.
(Example)
*
DVD 1
DVD 2
* Factory setting
Press ENTER you want to set.
The menu select is set.
• The DVD player support two remote control
codes: DVD 1 and DVD 2.
• Set the remote control code of the Remote
Control to the same setting.
• See page 14 for more information.