Keysight U1273A Guia De Inicio Rapido página 14

Continuity tests
Set up your multimeter as shown in the figure
below to perform continuity tests. Press
switch to the continuity test function (
shown on the display).
The beeper will sound as a continuity indication.
Press
and normal close (
– Normal open: Circuit is normally open, the
– Normal close: Circuit is normally closed, the
14
resistance measurements. Press
between the bias voltage (BiAS) display or
leakage current (LEAk) display, calculated
based on the bias voltage and corrected
resistance value, on the secondary display.
to switch between normal open (
Dual
E xit
beeper will sound when a short is detected.
beeper will sound when an open is detected.
Keysight U1273A/U1273AX Quick Start Guide
Dual
E xit
) contacts.
to switch
to
is
)