I Nstallation Location; F An; Use Of The Refrigerator Compartment - Listo RML 50-50b1 Instrucciones De Uso

BEFORE FIRST USE
Please clean the inside of the appliance and all the accessories before using it for the first time
(refer to the "Care & cleaning" paragraph).
INSTALLATION
I
nstallatIon locatIon
The appliance must be installed in a dry, well-ventilated room.
The appliance's energy consumption and efficient operation are affected by the ambient
temperature.
The appliance must not be exposed to direct sunlight.
The appliance must not be installed next to a radiator, a stove or any other heat source.
Only install the appliance in a location where the ambient temperature corresponds to the
climate class for which it was designed.
The climate class is on the rating plate located on the inside of the appliance.
The appliance must be positioned such that the plug is accessible.
The table below shows the correct ambient temperature for each climate class:
Climate class
SN
N
ST
T
Your Listo RML 50-50b1 refrigerator is classified "N/ST". If the room temperature is below
or above the indicated room temperatures, the performance of your appliance may be
affected and your food may spoil.
F
an
Make sure that air can always circulate behind and above the appliance. Please leave a clearance
of at least 10 cm between the top of the appliance and any kitchen equipment attached above
it; leave a clearance of 2.5 cm on each side and at least 10 cm between the back of the appliance
and the wall.
If the refrigeration appliance is installed next to another refrigerator or freezer, leave a clearance
of 5 cm on the sides, to prevent any condensation from forming on the outside of the appliance.
V.2.0
Room temperature
from +10 to +32°C
from +16 to +32°C
from +16 to +38°C
from +16 to +43°C
32

USE OF THE REFRIGERATOR COMPARTMENT

t
hermostat
The temperature selection button is located on the back of your refrigerator.
Turn the thermostat button clockwise: the appliance starts up automatically.
Setting "1" is the highest available temperature, i.e. the warmest setting.
Setting "7" is the lowest available temperature, i.e. the coldest setting.
- For optimal food preservation, set the thermostat to "4" (see diagram above). This setting
is for properly preserving fresh food.
- If you want to cool fresh foods quickly or you are using the appliance for the first time, choose
the "7" setting, making sure that the temperature in the refrigeration zone does not drop below
0°C. In this case, set the thermostat to "4" again.
- The temperature inside the appliance is a function of several factors, such as the room
temperature, the quantity of food stored, the frequency of the door opening, etc.
The "0" setting corresponds to the appliance's "off" position.
To completely shut down the refrigerator, unplug it from the power point.
Note: When the thermostat is set to the "7" position, you may hear the compressor running at
more regular intervals.
n
ote
• If the appliance is unplugged, switched off or in the event of a power failure, you
should wait 3 to 5 minutes before restarting it. Do not attempt to turn it on again
before this time has elapsed as the appliance will not start up again.
• It is best to install the appliance in the coolest part of the room to reduce energy
consumption. When the temperature in the room is too high, the refrigerator
temperature cannot reach the desired value.
33 V.2.0