Important; Reversing The Opening Direction Of The Door; D Efrosting; C Leaning - Listo RML 50-50b1 Instrucciones De Uso

IMPORTANT: Never try to detach an ice cube tray, that is frozen stuck in the freezer
compartment, with sharp or pointed objects as this may damage the refrigeration circuit. Use
a plastic scraper.

REVERSING THE OPENING DIRECTION OF THE DOOR

You can reverse the opening direction of the door of your refrigerator. To reverse the opening
direction of the door, follow the instructions below:
Note: all the parts removed must be kept as they will be needed to refit the door.
• Remove the top hinge cover (1).
• Using a sharp object, remove the plastic plug (5).
• Remove the two screws (2) that connect the top hinge (3) to the right side of the top panel.
• Lift the door carefully and place it on a padded surface so as not to scratch it.
• Remove the hinge pin (8) and transfer it to the free hole on the right side. Make sure you
push it all the way in.
• Remove the two bolts (7) retaining the lower hinge (4) on the right side.
• Remove the front levelling foot (9) and transfer it to the right side, as shown in the figure
below.
• Put the door in its new location making sure the hinge pin fits into the lower hinge ring
(hole).
• Screw the upper hinge (3), which was previously removed in point 3, to the left side. Make
sure the hinge pin fits into the upper hinge ring (hole).
• Slightly tighten the lower left hinge (4) and do not tighten the bolts until the door is closed
and level.
• Insert the plastic plug (5) in the exposed holes (right side).
• Replace the hinge cover (1).
1.
2.
3.
4.
5.
6.
7.
8.
9.
V.2.0
Door hinge cover
Door hinge screws
Upper hinge of the door
Lower hinge of the door
Plug
Small foot
Door hinge bolts
Door axis
Adjustable front foot
36

MAINTENANCE AND CLEANING

For reasons of hygiene, the inside of the appliance and the accessories must be cleaned
regularly.
d
eFrostIng
Unplug the appliance from the power point before defrosting.
To defrost the appliance :
- Choose a time when your appliance is not full.
- Pack your food in a bag and keep it cool (ideally, transfer it to another refrigerator).
- Leave the refrigerator door open.
- To speed up the defrosting process, you can place a container filled with hot water in the
compartment and close the door.
- Once defrosting is complete, empty the drip tray and clean the cavity.
WARNING: Do not use an electric heating device or any other mechanical or artificial device
to speed up the defrosting process.
- Do not use aerosol de-icers as they may be hazardous to health and/or contain substances
that could damage the plastic.
c
leanIng
Unplug the appliance from the power point before cleaning.
1. Remove the fresh food from the refrigerator. Wrap food in several layers of newspaper, cover
it and store it in a cool place (ideally, transfer it to another refrigerator).
2. Clean the appliance and accessories inside with a soft sponge and soapy, lukewarm water.
3. After cleaning, rinse with clean water and dry the parts thoroughly.
4. Once everything is dry, the appliance can be turned back on.
Keep the door seals clean at all times.
Never clean the appliance with a steam cleaner. Moisture could build up in electrical
components, leading to a risk of electric shocks! Hot steam can damage plastic parts.
The appliance must be dry before being switched back on.
IMPORTANT: Volatile oils and organic solvents can damage the plastic parts. This applies to
lemon juice or juice from orange peels, butyric acid, and cleaning products containing acetic
acid. Do not substances of this type come into contact with the parts of the appliance.
- Do not clean the appliance using abrasive products.
37 V.2.0