Display Layout; Folder Navigation And Icons; Page Navigation; Accessing Parameters - Ingersoll Rand R37-160 Información Del Producto

60313.16.03
EN

Display layout


Figure 30: Display Layout
Table 10: Display Layout
Key Name Description
A Folder Bar Uses tabs to graphically identify each folder.
B Title Bar Identifies current folder and page (underlined).
C Page Content Content of the current page.
D Dashboard Displays system status.

Folder navigation and icons


To move among the tabbed folders shown on the LCD display, press the
RIGHT and LEFT keys. The navigation rolls over from the last to the first folder
and vice-versa.
Table 11: Folder Bar Icons
Folder Icon Description
Name
Home System performance and status main
information. The first page of this folder is the
default page when the controller first powers up.
Operator System options and configuration settings.
Settings
Events System events log.
Trip History Details on the most recent trips.
Graphing On-board graphing of system data. (Optional for
some controllers)
Maintenance Status and notification setup for compressor
maintenance items.
General General settings such as Language, Time, and
Settings Units of Measure.
Integral Inter Module communication status and
Sequencing configuration.
Status Measurements or status from/of all analog and
digital I/O.
Factory Compressor tuning parameters. Also displays
Settings hardware and software versions.
80446339 Rev C
All manuals and user guides at all-guides.com

Page navigation


Once the desired folder is selected, press the DOWN key to move to the page
selection area and then use the RIGHT and LEFT keys to select the desired
page. Use the UP key to get back to the folder tabs.

Accessing parameters


After the desired page is selected, the page's parameters can be selected by
using the DOWN key. The cursor will move to the next parameter each time
the DOWN key is pressed. Use the UP key to go back to the previous one.
The cursor rolls over, so once the last parameter is selected, pressing the
DOWN key will navigate the cursor to the folder bar. If the first parameter is
selected, pressing the UP key will move the cursor to the page selection area.
Once selected, access parameters by pressing the ENTER key. Make changes
using the navigation keys and then enter the setting by pressing the ENTER
key again. After a parameter is accessed, pressing the ENTER key will enter
the current setting into the control program and navigate the cursor back to
the selected parameter on the page.
When the cursor is on a parameter that has an enabled/disabled box,
pressing the ENTER key will cause the setting to toggle.
This "X" icon appears on numeric entry windows as shown below. Placing the
cursor on it and then pressing the ENTER key will cancel the entry and any
changes that were made.
Not all pages have adjustable parameters . Some just have read-only
information .

Dashboard icons


The dashboard is intended to be a quick at-a-glance view of system status.
The following table lists standard dashboard icons and their definition.
Note that the color of these icons changes based on the state set by the
application while running.
Name
Network
Control
Service
Required
Unloaded
Loaded
Table 12: Title Bar Page Icons
Icon Description
Start of the page selection area.
Indicates that there are more pages available by navigating
right.
Indicates that there are more pages available by navigating
left.
Figure 31: Numeric Entry Window
NOTICE
Table 13: Dashboard Icons
Icon Description
Network control is enabled.
A service reminder is nearing or has expired
(i.e.: an air or oil filter needs to be changed).
Compressor is in the unloaded state.
or
Compressor is in the loaded state.
EN-0