Frequently Asked Questions - Marmitek IPTV Coax Pro Modo De Empleo

5. FREQUENTLY ASKED QUESTIONS

Link and Signal Quality lights are not lit
The IPTV Coax Pro™ node is unable to make a proper connection with
another node on the coaxial network.
x
Make sure the POWER light is lit on all IPTV Coax Pro™ nodes.
x
The signal between the two IPTV Coax Pro™ nodes may be too weak
to establish a connection. This may be caused by bad connections or
poor quality jacks (splitters, cables, connectors). Use high-quality F-
connector jacks, cables and splitters wherever possible.
x
Coaxial cables must not be bent, kinked or damaged.
x
Please ensure that no active coaxial signal amplifiers are installed
between two IPTV Coax Pro™ nodes.
x
Press and hold the RESET button for 10 seconds to restore the IPTV
Coax Pro™ node's factory settings.
Signal Quality indicator light turns red
The IPTV Coax Pro™ node is connected to another node on the coaxial
network. The signal quality between the two nodes is adequate but not
maximal. This connection is stable and fast enough to connect your high-
bandwidth internet devices. Please note that adding multiple coaxial
splitters, cables or other connecting materials may weaken the signal,
making the signal quality inadequate and turning the indicator light off.
RESET:
x
Hold 1 second to restart the IPTV Coax Pro™ node.
x
Hold 10 seconds to restore the IPTV Coax Pro™ node to its factory
settings.
Still have any questions that have not been answered here? Please check
www.marmitek.com.
10 © MARMITEK