Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7
The confirmation beep indicates that an accurate temperature measurement has been taken.
The result is shown on the display.
0-3
3-36
36+
Months
0-3
3-36
36+
Months
0-3
3-36
36+
Months
Green
Age range
Normal temperature
≥35.8 – ≤37.4 °C
0-3 Months
(≥96.4 – ≤99.4 °F)
≥35.4 – ≤37.6 °C
3-36 Months
(≥95.7 – ≤99.6 °F)
36 Months -
≥35.4 – ≤37.7 °C
adult
(≥95.7 – ≤99.9 °F)
8
For the next measurement, press Eject button
remove and discard used lens filter, and put on a new,
clean lens filter.
NOTE: Defaults to last age setting used if you do not
change.
The Braun ThermoScan ear thermometer turns off
automatically after 60 seconds of inactivity.
The thermometer can also be turned off by
pressing the Power button
.
The display will briefly flash OFF and it will
go blank.
Temperature-taking hints
Always replace disposable lens filters to maintain accuracy and hygiene. The right ear
measurement may differ from the measurement taken in the left ear. Therefore, always take the
temperature in the same ear. The ear must be free from obstructions or excess earwax build-up to
take an accurate reading.
External factors may influence ear temperatures, including when an individual has:
Factor
Poor probe placement
Used lens filter
Dirty lens
6
All manuals and user guides at all-guides.com
Yellow
Red
Elevated temperature
High temperature
>37.4 °C
(>99.4 °F)
>37.6 – ≤38.5 °C
>38.5 °C
(>99.6 – ≤101.3 °F)
(>101.3 °F)
>39.4 °C
>37.7 – ≤39.4 °C
(>103.0 °F)
(>99.9 – ≤103.0 °F)
to
Affects
In the cases below, wait 20 minutes prior to taking a temperature.
Factor
Extreme hot and cold room temperature
Hearing aid
Lying on pillow
Use the untreated ear if ear drops or other ear medications have been placed in the ear canal.
Memory mode
This model stores the last 9 temperature measurements.
1
To display the stored measurement, the thermometer must
be turned on.
2
Press the Mem button.
The display shows the temperature, and when releasing the
Mem button, the stored temperature for that memory number
is displayed, together with "M".
3
Each time the Mem button is pushed, the stored
reading and an M is displayed to indicate each
temperature measurement (eg. M2).
Memory mode is automatically exited by
not pressing the memory button for 5 seconds.
1
The last temperature taken is stored in its memory
and will be automatically displayed for 5 seconds
when it is turned on again.
Night light feature
The thermometer includes a convenient night light to illuminate
the display in a dim environment.
The light will turn on when you press any button. It will stay on until the
thermometer is inactive for up to 15 seconds even after temperature is
taken.
Changing the temperature scale
Your Braun ThermoScan is shipped with the Celsius (°C) temperature scale
activated. If you wish to switch to Fahrenheit (°F) and/or back from Fahrenheit
to Celsius, proceed as follows:
1
Make sure the thermometer is turned off.
2
Press and hold down the Power button
. After about 3 seconds
the display will show this sequence: °C / SET / °F / SET.
Affects
7
Publicidad
Tabla de contenido
