Connect - HP mp200 Manual Del Usuario

RED / GREEN / YELLOW / BLUE: Special function
Function key Video playback DVD Menu
Red Open DVD Menu
Green Toggle audio track
Yellow Switch the subtitle
Blue Change the Angle

Connect

There are three ways shown below to connect this player to your TV set. Please choose
the one that best applies to your TV/Stereo configuration.
Basic connection (standard definition):
Power Cord: Connect the DC power adapter to the mp200 HD Media Player.
Audio cable output: Using the supplied analog stereo cable, connect the mp200 audio
output to your TV set.
CVBS video output (NTSC or PAL): Using the supplied composite video cable, connect
the mp200 video output to your TV set.
Advanced connection (high definition):
Power Cord: Connect the DC power adapter to the mp200 HD Media Player.
Audio cable output: Connect the cables to TV set.
Component video cable for HD video output (720p, 1080i): Connect the 1/8" jack of
the AV (component) cable to the back of the mp200, and then connect the other end of the
component cable to the YPbPr input of your TV set.
HDMI connection (high definition):
Power Cord: Connect the DC power adapter to the mp200 HD Media Player.
HDMI output to TV (Up to 1080p): Using the supplied HDMI cable, connect one end to
the back of the mp200 and the other end to your TV set. Note that the HDMI port sends
digital video and audio signals through the same cable. In this configuration, the audio
output must be set to LPCM 2CH. Please refer to the audio section of the user's manual for
more information.
*HDMI output to HDMI receiver: Using the supplied HDMI cable, connect one end to
the back of the mp200 and the other end to your HDMI receiver, in this configuration,
the multichannel audio can be enabled and decoded by the HDMI receiver. Please
configure the mp200 audio output to HDMI RAW. Please refer to the audio section of
the user's manual for more information.
All manuals and user guides at all-guides.com
File browser
None
Options
Switch to Thumbnail
Back to home
8
Network function
Refresh
Options
None
Back to home