Programme Selection And Special Functions; Important - Candy CDI 5012 E10 Instrucciones Para El Uso

PROGRAMME SELECTION
AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)

IMPORTANT

The dishwasher has two very practical
functions:
- the "recommended" programme
(which is set in the factory and is
ideal for full-load daily use) for quick
and accurate selection;
- the memory function which saves
the last programme used, so that if
you regularly use the same washing
cycle, you do not have to re-set the
programme every time, thereby
saving time and effort.
"DEGREE OF SOILING" buttons
These buttons allow to modify the wash
intensity, according to how dirty the dishes
are. The wash time and temperature will be
modified.
+
Pressing the button the intensity of
wash will be increased, pressing the
–
button the intensity of wash will be
reduced and the wash time will be
remarkably shorter.
The combination of the buttons with the 4
main wash programmes enable to have 8
additional wash cycles.
IMPORTANT
When the dishwasher is switched on,
the "DEGREE OF SOILING" last used
will be indicated.
Programme settings
Open the door and place the dirty dishes
inside the appliance.
Press the "ON/OFF" button . The
display will show the "recommended"
programme, or the last programme
used.
To set another programme, press the
"PROGRAMME SELECTION" button
("PROGR.").
If you wish to choose the "DEGREE OF
SOILING", press the corresponding button.
If you wish to select an option, press the
option button (the corresponding indicator
light will light up).
The option button can be selected or
deselected WITHIN one minute of the
programme commencing.
Press the "START" button.
The length of the program will be shown on
the display alternating hours with minutes
[I.e.: 1 h (1 hour) / 25 (25 minutes)].
Close the door (after an audible signal
has sounded, the programme will start
automatically).
WHITIN one minute of the programme
commencing, another programme
can be selected, by pressing the
"PROGRAMME SELECTION" button
(it is also possible to change the
"DEGREE OF SOILING" setting).
"IMPULSE" programmes
The "IMPULSE" programmes use an
impluse washing technology, which reduces
consumption, noise and increases
performances.
IMPORTANT
The "intermittent" working of the
washing pump MUST NOT
considered a malfunction, it is a
characteristic of the impulse washing
so must be considered a normal
function of the programme.
14
Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops
automatically and the display will flash the
remaining time before the end of the cycle.
Close the door, without pressing any
buttons. The cycle will start from where it
left off.
WARNING!
If you open the door during the
drying cycle, an audible audio signal
advises you that the drying cycle has
not yet finished.
Changing a running programme
Proceed as follows to change or cancel a
running programme:
Open the door.
Hold the "RESET" button down for at
least 5 seconds (the running programme
will be cancelled).
The display will show the "recommended"
programme.
At this point a new programme can be set.
WARNING!
BE
Before starting a new programme,
you should check that there is still
detergent in the dispenser.
If necessary, top up the dispenser.
If there is any break in the power supply
while the dishwasher is operating, a
special memory stores the selected
programme and, when the power is
restored, it continues where it left off.
Programme end
A 5 second alarm will sound (if not muted)
3 times at 30 second intervals to signal that
the programme has ended.
Dishes can now be removed and the
dishwasher turned off by pressing the
"ON/OFF" button or dishes can be loaded
for a new cycle.
Option buttons
"ALL in 1" button
This option optimises the use of "ALL in 1"
("3 in 1"/ "4 in 1"/"5 in 1", etc...) combined
detergents. By pressing this button, the
selected washing programme is modified
to get the best performance from combined
detergents; furthermore, the salt and rinse
aid shortage lights are de-activated.
WARNING!
Once selected, this option keeps
being on (light on) also for next
washing cycles and it can be de-activate
(light off) only by pressing the button
once again.
IMPORTANT
When this option is selected, the
"RAPID" cycle is 10 minutes longer.
15