Publicidad
3
3
The groove in the MOLDINGS (R)
should be closer to the top edge.
These edges
should be even.
R
27G
Fasten ten ANGLE BRACKETS (27G) to the ENDS (A and B) and SHELF (G). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the edges of the ANGLE BRACKETS are even with the edges of the ENDS and SHELF.
Fasten the SMALL END MOLDINGS (R) to the ENDS (A and B). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: The SMALL END MOLDINGS do not have holes. Turn the screws into the groove of the MOLDINGS. Do not over tighten.
414723
R
A
B
www.sauder.com/services
G
27G
(10 used in this step)
BLACK 9/16" LARGE HEAD SCREW
(14 used for the BRACKETS)
27G
1S
Page 7
Publicidad
