Further Safety Directions; Residual Risks - Deltafox DG-CCS 1820 T Set Traducción Del Manual De Instrucciones Original

Podadora telescopica a bateria
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 149
GB
cated chain may either break or increase
the chance for kickback.
• Do not saw with the point of the blade
(cf. fig. b) or above shoulder height.
Do not lean over too far during the saw-
ing operation.
• Ensure that there are no objects lying
around on the ground that you can
trip over.

Further safety directions

• Keep the equipment, cutting attach-
ments and protective blade cover in
good condition in order to prevent injury.
• Ensure during any location change that
the saw chain is secured with the chain
brake and the chainsaw is switched off
and the finger does not contact the On/
Off switch. Carry the cordless pruner
with the chain and chain bar point-
ing to the rear. Attach the chain guard
for transporting the cordless pruner. If
dropped, check the equipment for sig-
nificant damage or defects.
• Never start the cordless pruner before
the chain bar, saw chain and sprocket
chain wheel covering are correctly as-
sembled.
• The cordless pruner is designed for
two-handed operation. Never work with
one hand or above shoulder height.
• Hold the power tool only on the insu-
lated handle surfaces, as the saw chain
can come into contact with concealed
power lines or the mains cable to the
equipment. Contact between the saw
chain and a live wire can make metal
parts of the equipment live and cause
an electric shock.
• Ensure you have a secure stance during
sawing. Do not work on a ladder, in the
tree or on unstable locations. Be very
cautious carrying out work on a slope.
68
• Keep your working area tidy. Only start
work if your working area is free from
obstruction and you have planned a
safe path of escape when felling timber.
• Place the claw stop securely with every
cut and do not begin with the sawing
before this.
• Be extremely careful during sawing
small bushes and branches. The thin
branch thicket can snag in the saw and
whip in your direction or make you un-
balanced.
• Do not cut wood that is lying on the
ground.
• Pay attention to a possible spring-back
during the sawing of a branch which is
under stress, if the stress force of the
wood is suddenly released. Danger of
injury exists.
• Check the safety status of the cordless
pruner, in particular the chain bar, chain
brake and the chain, before use.
• In the event that the cutting attach-
ment becomes jammed or stuck in the
branches, do not attempt to free the
equipment with the use of force. Switch
off the equipment immediately and re-
start it only after clearing the blockage.
There is a risk of injury!

Residual risks

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Cuts
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dg-ccs 1820 t

Tabla de contenido