FAILURE TO CHARGE
1. Travel lock may be engaged. Check by pressing power button (Figure A). If travel lock
indicator light turns white, turn off the travel lock by pressing and holding the power
button for at least 5 seconds.
2. Make sure voltage is present at the wall outlet (confirm with an appliance you know
is working).
3. Check to make sure adapter cord is plugged firmly into shaver. Twist the adapter
connector slightly to insure good electrical connection. If failure to charge still exists
while product is under warranty, return shaver to Andis for examination and/or
replacement.
FOR SHAVING
1. Keep the unit clean and dry when not in use.
2. Remove the protective cap (Figure A).
3. Check to make sure the outer foils and inner cutters are not damaged. Replace
damaged parts before using. For more information on replacement parts, contact
Andis or the nearest Andis authorized service station.
4. Ensure that the battery is charged.
5. Wash and dry your skin thoroughly prior to shaving.
6. Push power button once to turn shaver on. If shaver does not turn on, travel lock may
be engaged. Check by pressing power button again. If travel lock indicator light turns
white you will need to disengage the lock by pressing and holding power button for
5 seconds.
7. Gently stretch the skin of your face with your free hand while moving the shaver
slowly and smoothly against the grain of your beard. Using short, circular strokes will
make the hairs stand out from your face and make shaving easier. Hold the shaver at
a 90 degree angle to your face while maintaining contact with the foil.
8. In order to achieve the closest shave and avoid unnecessary wear on the foils, be sure
that both foils contact the skin simultaneously at all times. Holding the shaver
at an angle where only one foil contacts the skin will cause distortion of the foil and
may result in skin irritation.
9. To facilitate cutting and avoid foil wear, use minimal pressure to apply the shaver to
your skin.
10. To maximize shaving comfort, be sure to clean the shaver thoroughly after use.
6