User Maintenance - Andis PFS-1 Manual Del Usuario

USER MAINTENANCE

If shaver is to remain unused for a long period of time, store in a safe, cool, dry place. Do
not wrap cord tightly around shaver. Do not hang the shaver by the power cord. Other than
the recommended maintenance described in this manual, no other maintenance should be
performed. To contact Andis directly, please call our Customer Support Team at
1-800-558-9441 or email us at support@andisco.com.
IMPORTANT: For best shaver performance and results, it is recommended that you
replace your shaver's foil assembly and cutters every six months.
TO REPLACE FOIL ASSEMBLY
1. Grasp the foil assembly on both sides and gently lift it off the shaver (Figure B).
2. Position the replacement foil assembly over the cutters. Be careful not to damage the
foils. Gently slide the foil assembly down until it snaps firmly into place.
TO REPLACE CUTTERS
NOTE: Always replace the foil assembly when replacing the cutters.
1. To remove a cutter, grasp it on both sides and pull up (Figure C).
2. To replace a cutter, hold it on both sides and line up the small metal shaft on its
underside with the notch on the shaver drive and push down firmly until it snaps
into place.
3. Replace foil assembly.
CLEANING
Regular cleaning is necessary in order to maintain the optimal performance and
maximum comfort from your shaver. Shaver and foil assembly can be cleaned with
small brushed included and rinsed under water for a more thorough cleaning.
1. Grasp the foil assembly on both sides and gently lift it off of shaver (Figure C).
2. Gently tap the base of the foil assembly on a flat surface so that the hairs inside fall
out. Do not remove the foils or they may be damaged accidentally.
3. Lightly brush the hairs out from the cutters. You can remove them from the shaver if
necessary. Blow out any remaining loose hairs.
4. For a more thorough cleaning rinse parts and shaver under running water then allow
to dry with cap off.
5. Replace the cutters and foil assembly.
7