English - Hikmicro HM-G605-LENS Manual Del Usuario

Product appearance is for reference only and may
differ from the actual product.
1 Device Overview
The interchangeable lens series is often used with
handheld thermal cameras to expand the focal length of
the original camera to different ranges, so as to obtain
different FOVs and scene scopes.
The interchangeable lens series has three types. (See
1.1 )
There should be one interchangeable lens and one target
plate set (see 1.2 ) in the package.
2 Installation
Follow the diagram to remove the decorative ring on the
camera and install the interchangeable lens.
Note:
The handheld camera shown in the diagram is only for
demonstration.
3 Lens Calibration
3.1 Set up the calibration environment
Place the target plate on a flat surface with the
1.
"TARGET" facing the lens.
Power on the target plate to heat it (12 VDC).
2.
Start the calibration when the temperature of the
3.
plate rises (about 1 minute later after powering on the
plate).
3.2 Calibrate the lens
Start the handheld camera.
1.
Follow the prompt to input Interchangeable Lens SN
2.
and Interchangeable Lens Param.
Interchangeable
Lens SN
Interchangeable
Lens Param
Note:
● On some camera, the interchangeable lens may be
referred to as "Teleconverter".
● If no prompt pops up after starting the camera,
check if the lens is firmly mounted.
● If you accidently leave the calibration program, go
to Local Settings > Capture Settings >
Printed near the aiming
point of the lens
Printed on the lens
label
4

English

①