Leveling The Washer; Installing Your Washer - Haier HLP22P Manual De Uso

All manuals and user guides at all-guides.com

Leveling the Washer

Your washer has 4 leveling legs that are located on the 4 bottom corners. After
properly placing your washer in its final location, you may level the washer.
• Leveling legs can be adjusted by turning them counter-clockwise to raise the
washer and clockwise to lower the washer.
Note: If the machine is slanting more than 2˚ it will not work.

Installing Your Washer

Read the installation instructions carefully before beginning.
1. Connect the hot and cold water inlet hoses to the hot and cold water faucet.
2. Connect the other ends to their respective washer inlets located at the top rear of
the machine. Connect the red tinted hose fitting to the washer and the other end
to the incoming water supply.
3. Install the drain hose to the side of the washer using drain hose clamp. The drain
hose must be placed into a drainpipe or sink at least 1-1/2 inches in diameter.
Use the gooseneck drain hook to hold hose in place. To avoid possible water
back up, the drain hose must reach a height of at least 31-1/2 inches minimum
and 40 inches maximum.
4. Plug in the Washer to a regular 115 Volt / 60 Hz, 15 Amps outlet.
Note: Carefully inspect for any leaks around and back of the machine. If
there is a leak, turn off the unit and unplug it, then check if any
connections are loose. You may need to tighten any loose
connections.
CAUTION: If after completing these steps you are still unsure if unit has been
properly installed, contact a qualified installer. We recommend that the
washer be installed by a certified technician to ensure that it is
properly installed.
Installing Inner Plate
A. Open the top lid of the washing machine.
B. Install the inner plate on the outer tub by aligning the plate shafts to the tub cover
groves.
C. To install, insert on one side first and then snap in on the other side.
Note: Do Not use washer without installing the inner plate.
English
18