Important Operating Notes; Electrical Shock Hazard - HP Latex R Printer Serie Manual De Instrucciones

Two control IPS positions are available in the printer. Never operate the printer at the same time from
WARNING!
the two control IPS screens provided. Ensure there is nobody exposed on any printer work or maintenance area
before launching any control command on either of the control IPS screens.
Turn off the printer, using the branch circuit breakers located in the building's Power Distribution Unit (PDU), and call
your service representative in any of the following cases:
The power cord is damaged.
●
The drying or curing enclosures are damaged.
●
The printer has been damaged by an impact.
●
Liquid has entered the printer.
●
There is smoke or an unusual smell coming from the printer.
●
The printer's built-in Residual Current Circuit Breaker (Ground Fault Circuit Interrupter) has been repeatedly
●
tripped.
Fuses have blown.
●
The printer is not operating normally.
●
There is any mechanical or enclosure damage.
●
Turn off the printer using the branch circuit breakers in either of the following cases:
During a thunderstorm
●
During a power failure
●
Take special care with zones marked with warning labels.
There are no operator-serviceable parts inside the printer except those covered by HP's Customer Self Repair
program (see http://www.hp.com/go/selfrepair). Refer servicing of other parts to qualified service personnel.

Important operating notes

Never leave the printer without supervision when the power switch is turned on.
WARNING!
Automatic white-ink system maintenance cannot occur when the printer is completely powered down. If
CAUTION:
the printer will be unused for a long period of time (more than 48 hours), leave only the white-ink switch turned on,
and follow the instructions in the User Guide about power on/off modes.

Electrical shock hazard

The internal circuits and the drying and curing modules operate at hazardous voltages capable of
WARNING!
causing death or serious personal injury.
Turn off the printer using the branch circuit breakers located in the building's Power Distribution Unit (PDU) before
servicing the printer. The printer must be connected to earth at mains outlets only.
To avoid the risk of electric shock:
Do not attempt to dismantle the drying and curing modules, or the e-cabinet, except during hardware
●
maintenance tasks. In that case, follow the instructions strictly.
Do not remove or open any other closed system covers or plugs.
●
Do not insert objects through slots in the printer.
●
Test the functionality of the Residual Current Circuit Breaker (RCCB) every year (see the procedure below).
●
2 ENWW