General Information - Flama 5500FL Manual De Instrucciones

Centro de planchado
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DESCRIPTION
1. Main body
2. Water tank
3. Water tank handle
4. Filling hole
5. Iron
6. Temperature button
7. Temperature indicator
8. Steam button
9. Base of the iron
10. Cleaning indicator button
11. Cable organiser clip
12. Thermal insulation fixture

GENERAL INFORMATION

CAUTION
During operation or after ironing,
never place the hot base on
anything other than the thermal
insulation fixture.
Filling hole
Fill the water tank with water through the
filling hole. Make sure that the water does
not exceed the maximum level indicated
on the water tank. Use the tank handle to
handle the tank.
Temperature button
Turn the temperature button to set the
ironing temperature based on the fabrics to
be ironed.
Min – Minimum temperature position.
• – Indicated for synthetic fabrics and silk
(70 °C<T<120 °C).
•• – Indicated for wool (100 °C<T<160 °C)
••• Indicated for cotton (140 °C<T<210 °C)
Max – Maximum temperature position –
Indicated for linen (170°C<T<230°C).
Temperature indicator
When the appliance is plugged in, the
temperature indicator light switches on.
As soon as the iron reaches the selected
temperature, the light switches off. The
temperature indicator light switches on and
off during the iron's operation, indicating
that it is working properly.
Steam button
When the appliance has heated up to the
selected temperature and the temperature
indicator switches off, gently press the
steam button and steam will be sprayed
from the base of the iron.
Release the steam button for dry ironing,
without steam.
Cleaning indicator button
The appliance should be cleaned when the
cleaning button light switches on.
Before cleaning, prepare a container
with capacity above 300ml to collect the
wastewater; then, place the iron inside
the container and place the container on a
stable surface. An empty kitchen worktop
can also be used instead of a container.
For more thorough cleaning of the circuit,
check that the temperature button is in
the "Max" position before activating the
cleaning function.
NOTE: The cleaning might not be as good
or might not be carried out is in a position
English
15

Publicidad

Tabla de contenido
loading

Tabla de contenido