Before First Use - Flama 5500FL Manual De Instrucciones

other than "Max".
Press the cleaning indicator button for 2
seconds; an audible alarm is emitted.
NOTA: You should keep a distance from the
appliance during the cleaning process so
as to prevent burns by high temperature
steam.
The appliance enters into cleaning mode
and the cleaning indicator button light
flashes. After approximately 3 minutes, the
cleaning is complete, and the appliance
returns to operation mode.
The cleaning indicator button light switches
off.
Steam shot
A shot of steam can be activated by pressing
the steam button twice in succession.
Continuous steam
Press the steam button continuously for
steam ironing.
Cable organiser clip
When not in use, the power cable and the
steam supply hose can be tidied at the base
of the appliance, using the cable organiser
clip.
16
OPERATION

Before first use

Remove any sticker, protective film or
storage cardboard from the base.
Fill the water tank with water according to
the "Steam ironing" section, heat the iron to
the maximum temperature and iron a piece
of damp fabric for a few minutes to remove
any residue from the base, according to the
"Steam ironing" section.
NOTE: It is normal to smell a strange odour
coming from the appliance upon first use.
This odour disappears quickly.
NOTE: It is possible that some particles
leave the base when using the iron for the
first time. This is normal. The particles are
harmless and no longer leave the iron after
a short period of time.
NOTE: When plugging in the appliance, the
appliance may emit a pumping sound. This
is normal. The sound indicates that water
is being pumped from the base to the iron.
NOTE: A little steam may leave from base
during the heating process, which stops
happening after a few seconds.
Use
The appliance has two ironing modes. Dry
ironing or steam ironing can be used.
Dry ironing
Place the appliance on a stable and level
surface.
Always place the iron on the thermal
insulation fixture.
Connect the power cable plug to the wall
socket; the appliance switches on.
Turn the temperature button to the
intended setting, which depends on the
www.flama.pt