Porter Cable CPLDC2541S Manual De Instrucciones página 9

Accessories for this unit are available at the store the unit was purchased.
To Add Oil To Pump
CRANKCASE. Serious damage can result from even limited operation
unless filled with oil and broken in correctly. Make sure to closely follow
initial start-up procedures.
of the air compressor. This is due to plant testing and does not mean the
pump contains oil.
on critical components, thus reducing performance and compressor life.
Use air compressor oil only.
NOTE: Use an air compressor oil such as SAE-30 (API CG/CD heavy duty
motor oil). Under extreme winter conditions use SAE-10 weight oil.
1. Place unit on a level surface.
removing the dipstick.
debris. If air vent is blocked pressure
can build in crankcase causing damage
to air compressor and possible personal
injury.
2. Remove dipstick (A) and slowly fill
crankcase with oil. Crankcase capacity
is 8 fluid ounces (236.6 ml). Oil level
should be at the + (full) mark on the
dipstick.
NOTE: If the oil is added too quickly, it will overflow and appear to be full.
3. Replace dipstick.
ACCESSORIES
ASSEMBLY
DO NOT ATTEMPT TO OPERATE THIS AIR
COMPRESSOR WITHOUT FIRST ADDING OIL TO THE
COMPRESSORS ARE SHIPPED WITHOUT OIL. A small
amount of oil may be present in the pump upon receipt
Multi-Viscosity motor oils, like 10W 30, should not be
used in an air compressor. They leave carbon deposits
Drain tank to release
air pressure before
Make sure air vent (B)
in dipstick is free from
9- ENG
B
A
(+)Full
(-)Add
D24064