Publicidad
Step 13
Unfold the UPPER BACK (G) and lay it over your unit.
å
Make equal margins along all four edges of the UPPER
å
BACK (G). Push on opposite corners of your unit if needed to
make it "square".
Fasten the UPPER BACK (G) to your unit using the NAILS (III).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the HUTCH UPRIGHT (J) and SMALL SHELF (N).
Repeat this step for the LOWER BACK (H).
å
NOTE: Be sure the notch in the LOWER BACK fi ts into the
å
notch in the UPPER BACK.
NOTE: Perforations have been provided for access through
å
the BACKS. Carefully cut out the holes needed.
Page 18
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the HUTCH UPRIGHT (J)
and SMALL SHELF (N).
G
H
101736
Caution
III
NAIL
(45 used in this step)
Notch
www.sauder.com/services
Publicidad
