Publicidad
Step 18
Carefully stand your unit upright.
å
To insert the drawer into your unit, tip the front of the drawer down and
å
drop the rollers on the drawer behind the rollers on the unit. Lift the front
of the drawer up and slide it into the unit.
NOTE: To adjust the DRAWER FRONT, loosen the SCREWS that attach
å
the DRAWER FRONT to the DRAWER BOX FRONT. Make adjustments and tighten the SCREWS.
IMPORTANT: Before fastening the DOOR (Q) to the END MOLDING (X), be sure the DOOR is spaced
å
evenly between the drawer and BASE (AA).
Fasten the DOOR (Q) to the END MOLDING (X) on the LEFT END (B). Use four BLACK 9/16" LARGE
å
HEAD SCREWS (FFF) through the HINGES and into the groove in the END MOLDING.
NOTE: The SCREWS will tighten into the groove in the END MOLDING. Do not overtighten the SCREWS.
å
To make adjustments to the DOORS, loosen the SCREWS in the HINGES, make needed adjustments,
å
and tighten the SCREWS.
Fasten the DOOR PULL (TT) to the front surface of the DOOR (Q).
å
Use a BLACK 1-1/8" MACHINE SCREW (BBB).
NOTE: Be sure the post on the back of the PULL inserts
å
into the small hole in the front surface of the DOOR.
The post should insert into
the small hole in the front
surface of the DOOR.
BLACK 1-1/8" MACHINE SCREW
(1 used for the PULL)
www.sauder.com/services
TT
BBB
BLACK 9/16" LARGE HEAD SCREW
(4 used for the HINGES)
Drawer
Q
B
AA
FFF
101736
Pro Tip: Lift with your
legs. And, you know,
your arms.
X
Page 23
Publicidad
