Creating Your Own Program (Rms Play) - Sony TC-WE825S Manual De Instrucciones

Creating Your Own Program
(RMS Play)
By creating a program, you can play back tracks on
deck A in any order that you want. The Random
Music Sensor (RMS) function lets you create a program
of up to 28 tracks, from the 1st to the 14th tracks on
each side of the tape.
RMS buttons (RMS/START, SET, CHECK, DISPLAY)
RESET MEMORY A COUNTER
g
DIRECTION MODE
RMS
A a RELAY
RMS/START SET CHECK DISPLAY
– RMS +
0 (AMS) (AMS) )
Ø ø
ON OFF
p ª ·
PITCH CONTROL
CLEAR BACK FRONT
DOLBY NR
OFF ON ON FILTER
PAUSE REC MUTE REC
P R r
– +
§
0 / ) p ª / ·
1
Press RMS/START.
"RMS" and a flashing cursor appear in the
display.
2
Press ª (BACK) or · (FRONT) to select the
side of the tape.
ª or · appears in the display.
3
Press 0 or ) repeatedly until the track
number you want appears in the display.
·
0 3
FRONT
RMS 1 2 3 4 5 6 7 8 9 10 11 12 13 14
BACK
Side of the cassette
Track number
4
Press SET to store your selection.
To program the same track again, press SET once
more.
·
1 3
FRONT
RMS 1 2 3 4 5 6 7 8 9 10 11 12 13 14
BACK
Track number
Order on the program
B RESET MEMORY
AUTO REC LEVEL
5
4 6
3 7
2 8
1 9
AUTO CAL(STARTP) DUBBING A B
0 10
DECK A DECK B A+B REC HIGH/NORMAL
START(DECK BP)
FADER ARL
0 (AMS) (AMS) )
π SYNCHRO
p ª ·
B C S
PAUSE REC MUTE REC PHONES
P R r
§
Advanced Playback Operations
5
Repeat Steps 2 to 4 to program more tracks.
If "FULL" appears in the display
This means that you've already programmed 28 tracks
and can't program any more.
6
Press RMS/START to start RMS Play.
The peak level meters appear in the display.
To stop RMS Play
Press p (CLEAR) once. The RMS program still remains.
To cancel RMS Play
Press p (CLEAR) repeatedly until the peak level meters
appear in the display or eject the tape in deck A. When RMS
Play is canceled, the RMS program is automatically erased.
To alternate between the RMS and peak level meter
displays
Press DISPLAY.
z
You can play the program again after RMS Play ends
Press RMS/START.
Notes
• During RMS Play, you can only use CHECK, DISPLAY, p
on deck A, and p, 0, ) on deck B.
• The RMS function may not work properly if a blank space
between tracks is short.
• If there is a long blank space between tracks, the deck may
fast-forward a portion of the blank space.
• If your program includes a number for a track that does
not exist, the deck will skip that number during RMS Play.
Checking the order of tracks in the
program
Press CHECK.
Each time you press this button, the display shows the
track numbers in the order they were programmed.
After the last track in the program, "End" appears in
the display.
(Continued)
EN
9