Adjustment Instructions - BGS technic 408 Manual Del Usuario

INSTALL NOSE PIECE AND RIVET BAR
Riveting bar mounting
Fasten matching nose piece and rivet bar together when not in
use to prevent mismatching the sizes and for convenience.
USE
Open the handles and turn the rivet nut on the riveting bar.
Turn knob counter-clockwise after rivet nut setting
is complete to remove riveter from the rivet nut.

ADJUSTMENT INSTRUCTIONS

1. Proper adjustment of the riveter is necessary for efficient and easy operation.
2. The adjustment of the riveter will vary, depending on the size and type of rivet nut being used and
the hole size.
3. Adjust the riveter by opening the handles outward as far as possible and turning the outer cylinder
(3) clockwise to increase the number of threads on the mandrel protruding beyond the nosepiece
for larger rivet nuts and by turning the outer cylinder (3) counter-clockwise for smaller rivet nuts.
Fine adjustment can be made by turning the rival nut on the mandrel to position the rivet closer or
further away from the nosepiece, as long as the mandrel is threaded all the way through the rivet
nut.
4. Always assure that the mandrel is threaded into all threads of the rivet nut to prevent damage to
the threads on the mandrel and / or the rivet nut.
lf the handles are extended too far outward to provide enough leverage to pull the handles inward
5.
to set the rivet nut, turn the outer cylinder (3) clockwise or turn the rivet nut counter-clockwise
slightly to change the handle angle to provide the proper leverage.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Nose piece mounting
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed