Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
Symbols
To reduce the risk of injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return exhausted batteries to
your local collection or recycling point
Operating instructions
Note: Before using the tool, read the instruction book
carefully.

INTENDED USE

The machine is intended for hammer drilling in concrete, brick and
stone. It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY PACK
The battery pack charger supplied is matched to the Li-ion battery
installed in the machine. Do not use another battery charger.
The Li-ion battery pack is protected against deep discharging. When
the battery pack is empty, the machine is switched off by means of a
protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery pack to
cool down before recharging.
When the battery pack is charged for the first time and after prolonged
storage. the battery pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE OR INSTALL BATTERY PACK (See A)
Depress the battery pack release button to release and slide the
battery pack out from your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be sufficient.
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wu381.9

Tabla de contenido