Worx Professional WU381 Manual Del Usuario página 8

OPERATION
1
INSERTING AND REMOVING DRILL BIT IN SDS
Take care that the dust protection cap (2) is not damaged when
changing tools.
— INSERTING
Clean and lightly oil the bit before inserting. Insert the dust-free bit
into the bit holder with a twisting motion until it latches.
The bit locks itself. Check the locking by pulling on the tool.
— REMOVING
Retract back the bit holder locking sleeve (3) and pull out the bit.
Warning!Your new WORX Rotary Hammer Drill generates
powerful forces to get your job done quickly and effectively. These
forces may cause inferior quality SDS bits to break and jam in the
chuck,We therefore recommend that only high quality SDS bits be
used with this tool.
2
AUXILIARY HANDLE (See B)
Slide the handle onto the hammer and rotate to the desired working
position. To clamp the auxiliary handle rotates the handle clockwise.
To loosen the auxiliary handle, rotate the handle anti-clockwise.
Warning: Always use the auxiliary handle.
3
ADJUSTABLE DEPTH GAUGE(See B)
Fit the drill bit into the chuck. Loosen the depth gauge by rotating
the handle anti-clockwise. Slide the depth gauge until the distance
between the depth gauge end and the drill end is equal to the depth
of hole/screw you wish to make. Then clamp the depth gauge by
rotating the handle clockwise.
4
ON/OFF SWITCH (See C)
Depress the On/Off switch(5) to start and release it to stop your tool.
— ON/OFF SWITCH WITH VARIABLE SPEED CONTROL
Depress the On/Off switch to start and release it to stop your tool.
This tool has a variable speed switch(5) that delivers higher speeds
with increased trigger pressure - speed is controlled by varying the
pressure applied to the switch.
5
SWITCH LOCK (See C)
The switch trigger can be locked in the OFF position. This helps to
reduce the possibility of accidental starting when not in use. To lock
the switch trigger, place the direction of rotation control in the center
position.
6
FORWARD AND REVERSE ROTATION CONTROL (See C)
With the drill pointing away from you, push the forward/reverse-lever
to the left " "for forward rotation. Push the forward/reverse-lever
to the right for reverse rotation "
Warning: Never change the direction of rotation while the tool is
rotating, wait until it has stopped.
7
FUNCTION MODE SELECTION (See D)
The operation of the gearbox for each application is set with the
function mode selection switch (4). To change between functions,
depress the unlocking button (10) and rotate the selector to the
desired operating mode.
8
".