Key Automation SEL3 Instrucciones Y Advertencias Para Su Instalación Y Uso página 10

4.6 SELECTOR MATCHING
To enter in the matching mode you will need to do the following:
DESCRIPTION
Press and hold the receiver's P1 button for 3 seconds
until you hear a fast double beep.
Release button P1.
The yellow LED of the receiver will start flashing slowly.
Press and hold selector button P2
The yellow led of the selector will light up and the green
led of the receiver will flash briefly.
Release button P2.
A short double beep will signal the match.
The green led of the receiver will remain steady.
NOTES: To exit the matching procedure, simply quickly press button P1 on the receiver.
If the yellow led of the receiver continues to flash, it will be a sign that the combination was not successful.
A. Check that the radio channel is identical, both for the receiver and the selector.
B. Change channel; it may be that the chosen channel is occupied by other radio devices.
C. Check that the selector is not already matched; reset its memory and try again.
D. Check that the maximum number of matching selectors (4) has not been reached.
E. The selector number is automatically assigned according to the memorising order in the receiver.
4.7 RESETTING THE SELECTOR MEMORY
If it is necessary to reconnect the selector, it will be possible to reset its memory by performing the
following operations:
DESCRIPTION
Press and hold selector button P2 for more than 10
seconds.
Wait for the yellow led and the red led of the selector to
turn on.
Release button P2.
The selector will be restarted; a slow flash of the green
led will indicate that the selector is ready for matching.
4.8 DELETING A SELECTOR FROM THE RECEIVER
DESCRIPTION
Identify the number of the selector to be deleted
according to the memorising order. Press the P1 key and
count the flashes of the GREEN led
Press the receiver button P1 until you hear a double
beep. The yellow led will start flashing
Press the receiver button P1 again and check that the
number of flashes of the red led and beeps corresponds
to that detected in point 1.
Press and hold the receiver's P1 button for at least 3
seconds until you hear a long confirmation beep
NOTES: To exit the matching procedure, simply press button P1 4 times on the receiver until the red LED turns off.
EXAMPLE
P1 > 3 s
YELLOW
P2 >3 s
YELLOW / GREEN
GREEN
EXAMPLE
P2 > 10 s
YELLOW and RED
GREEN
EXAMPLE
P1
P1
P1
P1 > 3 s
BEEP
<0.5s
<0.5s
BEEP
BEEP
>1s + >1s
>2s