Key Automation SEL3 Instrucciones Y Advertencias Para Su Instalación Y Uso página 11

4.9 RESETTING THE MEMORY OF THE RECEIVER
If it is necessary to reconnect the receiver with the selectors, the memory can be reset by performing
the following operations:
DESCRIPTION
Press and hold receiver button P1 for more than 20
seconds.
The yellow led flashes. Do not release the P1 key.
The red led flashes very fast. You hear very fast beeps.
Do not release the key.
Wait for the steady red led of the receiver to turn on.
You hear a steady beep.
Release button P1.
The receiver will be restarted and after 4 seconds a
beep will be heard every second, a signal that the radio
receiver is ready to match the selectors.
4.10 SIGNALLING OF SELECTOR STATUS AND ERRORS
STATUS AND/OR
ERRORS
Unmatched device
Start matching via button
P2
Successful matching
Device matched
Receiver not reached
Communication error
between receiver and
central board
Central error
Selector battery low
Selector battery too low
Central battery low
NOTES: The Green led will flash only if the DIP3 is set to ON. The Red led will flash during radio
communication operations with the remote keyboards, only if the DIP3 is set to ON.
4.11 SIGNALLING OF RECEIVER STATUS AND ERRORS
STATUS AND/OR
ERRORS
Unmatched device
Start matching via button
P1
Successful matching
Device matched
GREEN LED
Slow Flash
Fast Flash
Fast Flash
YELLOW GREEN / RED
LED LED
Slow flashing green
Flashing
Slow
Fast flashing green
Fast flashing green
EXAMPLE
P1
YELLOW
RED
RED
YELLOW RED LED
LED BATTERY
On
Flashing
Flashing Flashing
Flashing
BEEP
DIP3=off ► a double long beep
when switching on
DIP3=on ► one beep every ½
second
a double
a fast double beep
no beep
BEEP
>20 s
<0.5s +
RED LED
ATTENTION
Double Flash
Flashing
Flashing
fast beep
<0.5s
>1s