Facom BAT.TESTU Manual Original página 8

A. Follow the instructions indicating when to turn the headlights on
All manuals and user guides at all-guides.com
and off or apply a load into the battery.
IN VEHICLE:
OUT OF VEHICLE:
B. The tester will resume testing after it detects
that the surface charge is removed.
10. Test the battery for few seconds.
11. Press the  /  key to select battery fully
charged or not if tester asks. Press «ENTER»
to confirm choice.
12. When the test is completed, the display shows the actual volts
and the actual CCA and internal resistance. {Press the  /  key
to read: SOH (STATE OF HEALTH) and SOC (STATE OF CHARGE)}.
13. One of the six test results will be displayed:
GOOD & PASS
*The battery is good and capable
of holding a charge.
GOOD & RECHARGE
*The battery is good but needs
to be recharged.
CAUTION
*The battery may be serviced but decrease
the capability of starting the engine gradually.
The battery may fail under extreme climate
conditions. There may be a poor connection
between the vehicle and the battery affect the
charging function. Please pay attention to the
battery for replacement consideration and
charging system checking.
8
SURFACE CHARGE
IN VEHICLE? YES
SURFACE CHARGE
IN VEHICLE? NO
TURN HEADLIGHTS
ON FOR 15 SECS
TESTING
TESTING
IS BATTERY
CHARGED?
YES/NO
GOOD & PASS
VOL:
CCA : xxx CCA/SAE
IR:
GOOD &
RECHARGE
VOL:
CCA : xxx CCA/SAE
IR:
CAUTION
VOL:
CCA : xxx CCA/SAE
IR:
xx.xx V
xx.xx mΩ
xx.xx V
xx.xx mΩ
xx.xx V
xx.xx mΩ