Battery installation
6.
Disconnect the vacuum hose (22) from the squeegee (11).
7.
Disconnect the recovery water drain hose (16) from the
bracket (17).
8.
Open the cover (6).
Grasp the recovery tank (A, Fig. 2) in the area (B) and
9.
slightly raise it.
10.
Disconnect the vacuum hose (C) from the tank, then
remove the tank (A) with the hoses (D) and (E).
11.
Install the batteries on the machine according to the
diagram (28).
Install the tank (A, Fig. 2) by performing steps 6 to 10 in
12.
the reverse order.
Battery charging
13.
Charge the batteries (see the procedure in Maintenance
chapter).
BEFORE MACHINE START-UP
Brush or pad-holder installation
NOTE
Use either the brush (54) or the pad-holder (55) according to the type of loor to be cleaned.
1.
Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2.
Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3.
Place the brush (54) or the pad-holder (55) under the deck.
4.
Lower the deck (10) by using the handlebar (2).
Engage the brush/pad-holder by pressing the brush/pad switch (65) for a few seconds. If the procedure is dificult, manually
5.
turn the brush/pad-holder counter-clockwise (60).
Brush/pad application guide (suggestions only)
Types of brushes available
Concrete
Terrazzo loor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing
Marble
Vinyl tiles
Squeegee installation
6.
Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank illing
7.
Open the recovery water tank cover (41) and engage the support rod (59).
Use the iller neck (45) to ill the tank (32) with a solution suitable for the work to be performed. Do not ill the solution tank
8.
completely, leave a few centimetres from the edge. Always follow the dilution instructions on the label of the chemical product
used to prepare the solution. The solution temperature must not exceed 104°F (40°C).
CAUTION!
Use only low-foam and non-lammable detergents, intended for automatic scrubber applications.
Adjustments
Adjust the handlebar (2) with the knobs (3) to reach a comfortable position.
9.
All manuals and user guides at all-guides.com
Midlite Grit 180
Razor SV17
INSTRUCTIONS FOR USE
B
C
A
D
Figure 2
Midgrit 240
909 6309 000(3)2009-11
ENGLISH
E
S310233 A
Prolite
Union Mix
11