Assembly - Layher 1401101 Instrucciones De Montaje Y Uso

}

5. ASSEMBLY

Observe the general directions for assembly and use on pages 4 – 5. The
assembly examples shown are intended for use indoors up to a maximum
platform height of 12 m and outdoors up to a maximum platform height of
8 m. Snap the snap-on claws of all parts into the ladder frames from above.
Level the tower after the basic assembly process. This is done using the
threaded spindles of the castors 1.
The castors must be locked during assembly, modification or
dismantling, and when there are people on the scaffolding.
Wedges in the system must be hammered home until the blow
bounces off. Screw couplers must generally be tightened (50 Nm).
On the topmost scaffolding level, a double guardrail
beam 17 can be fitted instead of two rear guardrails. Please remember
in this case that for assembly and dismantling two additional rear
guardrails must be present to ensure collective side protection. These
can be removed again after insertion of the double guardrail or of the
tower beam.
The item numbers of the parts relate to the individual part list on page
27 – 29.
Basic assembly
Tower model 1401101
Safety Structure P2
16
1. Insert the castors
them against falling out by fastening the wing screws on the spindle
nuts.
2. Connect the two ladder frames
Suspend the access deck
2.00 m ladder frames 13.
Basic assembly
Tower models 1401102, 1401104, 1401106,
1401108 and 1401110
or a tower
1. Insert the castors
against falling out by fastening the wing screws on the spindle
nuts.
2. Connect the mobile beams
and a deck 24.
3. Fit two 1.00 m ladder frames
secure them using spring clips 14.
Further assembly is in accordance with page 13 "Assembly of inter-
mediate platforms".
1 into the 2.00 m ladder frames
13 using two double guardrails 16.
23 from the fourth rung from below of the
1 into the mobile beams 5/6
5/6 using a basic tube
12 onto the mobile beams and
13 and secure
and secure them
7 / basic strut 8
11