Starting Operation - Snapper ESXDCS82 Manual Del Usuario

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
Remove the battery pack from the chain
saw before checking the chain tension or
making adjustments to the chain. Wear
protective gloves while touching the chain,
bar or areas around the chain.
Pull the chain in the middle of the lower
„
side of the bar away from the bar. The
gap between the cutter in the chain and
the bar should be between 3mm - 4mm.
If you need to adjust the chain tension,
„
please refer to the section "ADJUSTING
THE CHAIN TENSION" later in this
manual.
TO iNSTALL BATTERY PACK
See Figure 2.
Align the battery pack with the battery
„
compartment on the chain saw.
Grasp the chain saw (item 3) firmly.
„
Push the battery pack into the battery
„
compartment until the latch locks into
place.
You should hear a "click" once the battery
„
is installed.
TO REMOVE BATTERY PACK
See Figure 2.
Press the battery release button (item
„
18) on the chain saw. This will cause the
battery to raise out of the tool slightly.
Grasp the chain saw (item 3) firmly, and
„
pull the battery pack out of handle.
CHECKiNG THE CHAiN LUBRiCANT
See Figure 2.
Check the amount of oil in the chain saw
„
by looking at the oil level gauge (item
7). If the oil level is low, follow the steps
shown in section "ADDING CHAIN &
BAR LUBRICANT" of this manual.
English (original instructions)
wARNiNG
Check the chain tension before each use
of the saw.
Never operate the chain saw without
sufficient chain lubrication as this might
damage the saw and is a threat to safety.
Check the chain lubricant level before each
use!
In order to prevent kickback, please follow
these safety instructions:
Never cut with the tip of the guide bar! Be
„
careful when continuing from previous
cuts.
Always start cutting only when the chain
„
saw is already running.
Make sure that the saw chain is always
„
properly sharpened.
Never cut through more than one branch
„
at a time! When lopping off branches, be
careful not to touch any other branches.
When cross-cutting, pay attention to
„
trunks standing very close to each other.
If possible, use a sawing trestle.
HOLDiNG THE CHAiN SAw See figure 8
Always hold the chain saw with your right
hand at the rear handle and your left hand at
the front handle.
Grip both handles with the thumbs and the
fingers around. Ensure that your left hand is
holding the front handle so that your thumb is
underneath.

STARTiNG OPERATiON

Before starting for operation, you should
„
install the battery pack in the machine.
Press the on/off switch (item 40), this
„
makes the switch trigger operational.
starting for operation.
Start the machine: Press the Safety lock-
„
off button (item 4), and then press the
switch trigger (item 5).
8
wARNiNG
wARNiNG