LABBOX LBX MF12 MUFU-020-001 Manual Del Usuario página 4

Characteristics
1. Double insulation ceramic inner chamber with stable performance.
2. Efficient insulation and three side heating of special alloy heating wire to provide optimum temperature
uniformity.
3. High precision micro-computer controller and accurate sensor.
4. Double-shell hollow thermal insulation and double ventilation duct with excellent ventilation, quick
internal cooling.
5. Multiple safety protection measures, such as thermocouple failure, over door opening electrical outage,
audio-visual alarm, etc.
Installation and operation
1. Open the package, check the furnace and make sure that no part is damaged. Place the furnace on
smooth ground or on a table. The equipment should avoid contact with vibrating surfaces.
2. Install the power switch at the original power line. To make sure the equipment operates safely, furnace
and controller must be grounded reliably.
3. Connect the controller direction to the power line. Turn on the power and set the temperature on the
meter. It starts heating when the indicator light of the meter turns green. Adjust the power to reach the
target temperature as it is needed, but make sure the voltage and electric current of the product will not
surpass the rated power.
Attentions
Install the outer ground protection to ensure safety of machine and experiment;
ensure power as the machine requires.
It is forbidden to use this equipment in inflammable, explosive, poisonous or
strong corrosive experiments.
Make sure the equipment is horizontally installed.
Non-professionals are not allowed to disassemble and repair this machine.
Pay attention to the setting temperature when dealing with inflammable matters.
Make sure to dry the resin container, if the temperature is set too high by
accident, the container could be dissolved and then fall on the heater, which could
cause fire.
Overfilling of sample will lead to overheating of working room, which could
dissolve the inflammable material and cause fire.
4