LABBOX LBX MF12 MUFU-020-001 Manual Del Usuario página 8

PV input filter
FILt
Power frequency
Fru
and display unit
Output highest
OPH
limit
OEF OPH valid range
Senior function
AF
code
SPL Lower limit of SV
SPH Upper limit of SV
Limit of
SPr temperature
rising speed
Auto running
PonP
when power on
EP1~E Senior function
P8 code
The value of FIL will determine the ability of filtering noise.
If great interference exists, then you can increase parameter
"FIL" gradually to make momentary fluctuation of measured
value less than 2 to 5.
When the instrument is being metrological verified, "FIL" s can
be set to 0 or 1 to shorten the response time.
50C --fequency 50Hz,display unit ℃. 50F-- fequency
50Hz,display unit F.
60C --fequency 50Hz,display unit ℃. 60F-- fequency
50Hz,display unit F.
When PV<OEF,max limit 100%
When PV<OEF,OUTP output highest limit is OPH,
When PV>OEF,no limit ,100% output
Note:if you want to avoid too quick temperature raising, and
temperature is lower than 150C, only 30% is allowed for heating
power, then you can set:
OEF=150.0 ℃, OPH=30%
AF=A*1+B*2+E*16+G*64
A=0,HdAL and LdAL is for Hysteresis alarm;A=1,they are absolute
alarm
B=0,single lop alarm, B=1,Dual loops alarm
E=0,HIAL ,LOAL are absolute highest alarm and howest alarm
E=1,HIAL,LOAL are hysteresis highest alarm and hysteresis
lowest alarm
G=0,sensor allow ,. G=1,not allow higher than highest alarm
value
Set it as 0 unless an expert tells you to change.
Mininmum value of SV
Maximum value that SV allowed to be.When SPH=400,the SV
range will 0～400℃.
If SPr is set as valid, when controller works, RUN light will shine
if wrong or unormal speed occurs.
Cont, controller stop work
StoP, when power on, it's in stop status.
Run1, continue working
dASt, if now alarm, then work, if alarm, stop working
HoLd,(only for AI-518P),if accident short of electricity, stop work.
Can set 1~8 field parameter. If not need or less than 8, can set it
as nonE.
8
1
50C
100
3200
0
0
1200
0
cont