LUND 66932 Manual De Usuario página 10

GB
be replaced with a new one which is free of defects if these components are damaged. If
the plug has a ground contact, it must be connected to a power supply socket which is also
equipped with a ground contact.
Instructions for use
Warning! The appliance does not remove gaseous pollutants such as carbon monoxide
(CO) and must not be used for smoke removal. Before using the appliance, make sure it is
properly assembled. During operation, do not allow water or other liquids to enter the appli-
ance. Do not spray fl ammable liquids near the appliance. Do not use the appliance in a room
where insect repellents or oil-containing substances such as incense have been sprayed.
The appliance must not operate in rooms with high humidity and/or high temperature, e.g.
bathroom or kitchen. Do not use the appliance even in rooms exposed to high temperature
fl uctuations. These conditions may cause condensation to form inside the appliance. The ap-
pliance does not replace regular cleaning and airing of rooms. Do not place fi ngers or other
objects in the appliance vents. Use only original fi lters supplied with the appliance or replace-
ment ones specifi ed by the manufacturer. Maintenance of the appliance should be carried
out in accordance with the manual. Do not use aggressive substances, solvents, caustics,
alcohol, petrol or abrasives for cleaning. The appliance may be used by children aged 8
years and over if they are supervised or instructed to use the appliance in a safe manner and
if they understand the risks involved. Cleaning and maintenance should not be carried out
by children unless they are 8 years or older, and are supervised. Keep the appliance and its
power cord out of reach of children under 8 years of age.
APPLIANCE OPERATION
Preparing for operation
Unpack the appliance by removing all packaging components. The covers can be secured during transport with adhesive tape,
which must be removed. The fi lters can be factory packed in plastic bags. Before starting operation, remove the fi lters from the
bags and install them in the correct order and in the correct manner in the appliance. Clean the outer surfaces of the appliance
according to the instructions in the section "Appliance maintenance".
Installation of fi lters
Warning! Before removing the fi lter cover, make sure that the appliance is disconnected from the power supply. and the power
cord is unplugged from the power supply socket.
Caution! If the appliance has more than one fi lter, always replace all fi lters.
Remove the fi lter cover (II).
Remove the fi lter(s) by pulling the ribbon at the edge of the fi lter(s) (III).
The fi lter(s) should be installed in such a manner that the ribbons are placed outside and allow easy removal of the fi lter. Installing
the fi lter wrong will result in incorrect air fi ltration and the appliance will not function properly.
After the fi lter(s) have been installed, the appliance cover must be mounted.
Air quality sensor
An air quality sensor is located on the side wall of the appliance, under the fl ap. Periodically, every two months, open the fl ap and
then use a swab on a stick moistened with water to clean the slots indicated in the illustration (V). After cleaning, dry the slots with
a dry swab. If there are vents around the sensor fl ap, they should also be cleaned with a damp cloth and then dried with a dry cloth.
UV fl uorescent lamp
Warning! The fl uorescent lamp can be hot during and immediately after operation. Wait until it cools down on its own before
replacing it.
A UV fl uorescent lamp emits ultraviolet UV-C radiation, which has antibacterial properties. The fl uorescent lamp is subject to
natural wear and should be replaced after approx. 8,000 hours (approx. 11 months) of operation. The fl uorescent lamp should be
O R I G I N A L I N S T R U C T I O N S
10