Troubleshooting - Craftsman 138.98818 Manuel Del Operador

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT A QUALIFIED SERVICE
DEALER.
PROBLEM
Handle is loose.
Mower will not start
Mower is cutting grass
unevenly
Mower is not mulching
properly
Mower is hard to push
Mower is not bagging
properly
Mower vibrating at higher
speed
Motor stops while cutting

TROUBLESHOOTING

POSSIBLE CAUSE
Handle locks are not locked.
The battery charge is low.
Lawn is rough or cutting
height is not set properly
Wet grass clippings are sticking
to the underside of the deck.
The rear of the mower and
blades are dragging in heavy
grass or the cutting height is
too low.
Cutting height set too low
The mulch plug is not
removed.
Blade is unbalanced,
excessively or unevenly worn
Bent motor shaft.
Cutting height set too low
15 — English
SOLUTION
Lock upper and lower handle
locks.
Charge the battery.
Adjust the cutting height.
Wait until the grass dries before
mowing.
Raise the cutting height.
Raise cutting height.
Make sure the mulch plug is
removed.
Replace the blade.
Stop the motor, remove battery.
Inspect for damage. Have
repaired by an authorized
service center before restarting.
Raise the cutting height