Hitachi Koki C 10RA3 Manual De Instrucciones página 16

English
RIP FENCE INDICATOR (FIG. T)
NOTE: The rip fence indicator points to the scale on
the front of the table saw. Measurement shown by the
indicator will provide the user with accuracy up to 1/16
of an inch. Measurement shown is the distance from the
blade to the side of the fence closest to the blade.
1. To check the accuracy, measure the actual distance
(1) to the side of the rip fence. If there is a difference
between the measurement and the indicator, adjust
the indicator as shown next.
2. Loosen the indicator screw (2). Slide the indicator to
the correct measurement position on the scale, then
retighten the screw (2).
Fig. T
1
TABLE EXTENSION SCALE POINTER (FIG. T-1)
The table extension scale pointer (1) should be at 13.5
inches on the scale when the extension is in the closed
position. If not, loosen the holding screw (2), position the
pointer over 13.5 inches and re-tighten the screw.
Fig. T-1
1
2
2
– 16 –
ADJUSTING THE CUTTING LINE INDICATOR (FIG. U)
1. Take off the cover (1) by loosening screws (2).
2. Adjust the pointer (3) to align to the blade.
3. Mount the cover on the table to fix the pointer.
NOTE: The pointer was set up to align to the right side
of the blade when packing.
Fig. U
3
ADJUSTING CAM LOCKING LEVER (FIG. V)
If the extension table moves when it is open and locked,
then the cam locking lever (1) may be loose and need
adjustment, therefore, adjustment to the cam locking
lever is necessary. To adjust the locking lever tension,
turn the bar (2) with a 10 mm wrench until it is tightened,
but do not over tighten.
Fig. V
13
1
2
1
2