Publicidad
Step 3
Separate the EXTENSION SLIDES (X) from the EXTENSION RAILS (W)
å
as shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (W) to the ENDS (A and B) and SHORT
å
UPRIGHTS (D). Use sixteen GOLD 5/16" FLAT HEAD SCREWS (PP).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
å
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL out to fi nd the other hole that lines up with the hole in the END. Turn
a SCREW into this hole.
Hole
M3
Open end
GOLD 5/16" FLAT HEAD SCREW
(16 used in this step)
www.sauder.com/services
X
Push the black lever in and pull the SLIDE from the RAIL.
W
W
Surface with
HIDDEN CAMS
PP
Finished edge
W
M3
W
W
Surface without
B
HIDDEN CAMS
W
D
W
Open end
409242
Open end
A
Open end
W
D
W
Finished edge
Open end
Page 7
Publicidad
