Tightening Torques - DGD P1908E Guia De Inicio Rapido

1 Adjusting the position of components
Components can be turned if multiple spindle arrangements are too crowded:
• Size 1 in 15° increments.
• Size 2 – 4 in 10° increments.
Secure the spanner contact surfaces on the nutsetter spindle or component in a vice with plastic jaws. Place
in position, do not tighten!
1.1

Tightening torques

CAUTION!
Risk of flying parts.
Components of the nutsetter spindle may rotate, come loose and cause injury.
Observe the tightening torque for the cap nuts. The tightening torque is the same for all sizes.
Size
1
2
3
4
1) Different setting due to leverage effect of the hook wrench
16b_Anzugsmomente en.fm, 26.11.2010
&BUTS& shown
&BTS& shown
Tightening torquet Tightening torque
Target Adjustment
lbf.ft (Nm) ±5% lbf.ft (Nm) ±5%
37 (50)
63 (85)
63 (85)
81 (110)
P1908E 2009-04
EN
Adjusting the position of components
Unscrew the cap nut counterclockwise.
➔
Align the transducer.
➔
Hook wrench
1)
Order no.
32 (43) 933336
54 (73) 933337
54 (73) 933338
68 (92) 933339
Torque wrench
Order no.
9 × 12 933340
3
1