Specific Safety Rules - Worx WT645K Manual Del Usuario

b) Do not force tool. Use the correct tool for your application. The correct tool will do
the job better and safer at the rate for which it is designed.
c) Do not use tool if switch does not turn it on or off. Any tool that cannot be controlled
with the switch is dangerous and must be repaired.
d) Disconnect the plug from the power source before making any adjustments,
changing accessories, or storing the tool. Such preventive safety measures reduce the
risk of starting the tool accidentally.
e) Store idle tools out of reach of children and other untrained persons. Tools are
dangerous in the hands of untrained users.
f) Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained
tools, with sharp cutting edges are less likely to bind and are easier to control.
g) Check for misalignment or binding of moving parts, breakage of parts, and any
other condition that may affect the tools operation. If damaged, have the tool
serviced before using. Many accidents are caused by poorly maintained tools.
h) Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool, may become hazardous when used on another
tool.
5. SERVICE
a) Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
b) When servicing a tool, use only identical replacement parts. Follow instructions
in the Maintenance section of this manual. Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of electric shock or injury

6. SPECIFIC SAFETY RULES

a) Hold tool by insulated gripping surfaces when performing an operating where the
cutting tools may contact hidden wiring or its own cord. Contact with a "live" wire
will make exposed metal parts of the tool "live" and shock the operator.
ADDITIONAL SPECIFIC SAFETY INSTRUCTIONS FOR BELT
SANDER
1. Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
2. Fully unwind cable drum extensions to avoid potential overheating.
3. When an extension cable is required you must ensure it has the correct ampere rating for your
power tool and is in a safe electrical condition.
4. Ensure your mains supply voltage is the same as indicated on the rating plate.
5. Your tool is double insulated for additional protection against a possible electrical insulation
failure within the tool.
6. Always check walls, floors and ceilings to avoid hidden power cables and pipes.
7. After long working period external metal parts and accessories could be hot.
8. Wear eye protection when operating this tool.
9. If possible ensure the workpiece is firmly clamped to prevent movement.
10. Your finishing sander is a hand held tool, do not clamp your finishing sander.
11. Before sanding check the area is free of nails, screws, etc.
12. Never stop the finishing sander paper by applying a force to the paper.
13. Only use paper in good condition. Do not use with a torn or worn paper.
Palm Sander
NA-WX645K-M-051107.indd 3
All manuals and user guides at all-guides.com
03
WT645K
2005-11-7 9:17:28