Ice & Water - Kenmore 111.7302 Serie Manual De Uso Y Cuidado

Problem
Icemaker is not
making ice.
Ice has bad taste or
odor.
Icemaker is making
too much ice.
TROUBLESHOOTING GUIDE
Possible Causes
Refrigerator was recently installed or
icemaker recently connected.
Icemaker not turned on.
The refrigerator is not connected to
a water supply or the supply shutoff
valve is not turned on.
Icemaker shutoff (feeler arm)
obstructed.
Water supply contains minerals such
as sulfur.
Icemaker was recently installed.
Ice has been stored for too long.
The food has not been stored
properly in either compartment.
The interior of the refrigerator needs
to be cleaned.
The ice storage bin needs to be
cleaned.
Icemaker shutoff (feeler arm) is
obstructed.
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker to
begin making ice.
Locate the icemaker on/of button and confirm that
it is turned ON.
Connect refrigerator to the water supply and turn the
water shutoff valve fully open.
If your icemaker is equipped with an ice shutoff arm,
make sure that the arm moves freely.
A water filter may need to be installed to eliminate
taste and odor problems.
NOTE: In some cases, a filter may not help. It may not
be possible to remove all minerals / odor / taste in all
water supplies.
Discard the first few batches of ice to avoid discolored
or bad tasting ice.
Ice that has been stored for too long will shrink,
become cloudy, and may develop a stale taste. Throw
away old ice and make a new supply.
Rewrap the food. Odors may migrate to the ice if
food is not wrapped properly.
See the Care and Cleaning section for more
information.
Empty and wash the bin (discard old cubes). Make
sure that the bin is completely dry before reinstalling
it.
Empty the ice bin. If your icemaker is equipped with
an ice shutoff arm, make sure that the arm moves
freely. Reinstall the ice bin and wait 24 hours to
confirm proper operation.
32
ICE & WATER
Solutions