Setting Up The Camera - Polaroid Econo ID-104 Manual Del Usuario

Setting up the camera

Setting up the camera is simple; follow these steps and your
ID-104 Camera will be ready to take photos in no time.
Note:
previous The camera
Preparing the camera
To set up the camera and turn it on:
1
Pull out the silver release pin (h) on the right side of the
camera base with the camera back facing you. While
holding the knob out, firmly grasp the camera head from
the bottom with your left hand and swing it up into the
upright position. Release the knob. The camera head clicks
into place when the camera is fully upright.
2 Tighten the large black locking knob (i) under the camera,
preventing it from moving on its base.
3 Plug the small end of the AC power supply into the socket
on the back of the camera (j). Plug the power cord into a
grounded AC outlet. If you prefer to use the rechargeable
battery, refer to the instructions in this guide.
4 Adjust the aperture switch (r) on the front of the camera for
the recommended f-stop by moving the switch to the
desired setting.
Film Speed
ASA 80
ASA 100
ASA 125
ASA 3000
Note:
temperatures, you may have to adjust the settings. Refer to
the film instructions for details.
5 Turn on the ID-104 Camera:
Deluxe model. Turn the camera on by turning the key (g)
clockwise 90° to ON. The display reads "Load Film" if the
camera does not contain film, "Pull Film" if the film has
been loaded but the dark slide has not been pulled, and
"Wait" for a warm-up period of about 15 seconds if the
camera contains film. After warm-up, it reads "Ready".
8 English
All manuals and user guides at all-guides.com
The following instructions refer to the callouts in the
(page 6)
Use these settings at 75°F (24°C) and above. At colder
section.
Aperture
f11-1/2
f11-l/2
f16
f64
Setting up